
Wits engineers show a magnet beside ordinary multimode fibre changes the light inside it. What the Optics Letters result proves, and what it doesn't yet.
Engineers at Wits University have shown that a magnet placed beside an ordinary multimode optical fibre changes the light travelling through it. The effect had gone unnoticed for more than 50 years because the standard maths used to model fibre leaves out the part of the light that a sideways magnetic field acts on.
The work, by MSc student Mohammed Raiyan Sharif and Professor Mitchell Cox of the Wits Optical Communication Lab, was published in Optics Letters and announced by the university on 11 November. It is basic physics, done in Johannesburg with a 3D-printed rig, and it points at a practical use South Africa has plenty of need for: sensing current in power cables and substations without wrapping fibre around the conductor.
It is a laboratory result. No sensor exists yet, and the researchers say so.
Light in glass rotates slightly in a magnetic field, an effect Michael Faraday first observed in 1845. Fibre-based current sensors already use it, but the field has to run along the fibre, so the fibre is usually coiled around the cable being measured.
Sharif and Cox report a transverse version, where the field comes from the side. Fibre theory since the 1970s has relied on a shortcut called the weak guidance approximation, which treats light as vibrating only across the fibre and drops a small component that points along it. That component is strongest near the edge of the core in step-index fibre, where the glass changes abruptly, and it is what a sideways field couples to.
To test it, they fixed strong magnets beside a stationary multimode fibre without touching it and filmed the speckle pattern the light makes at the far end. At a field of 0.24 tesla, about what sits near a strong neodymium magnet, the pattern for light polarised across the field shifted until it was about 84% similar to the original. When the light was polarised in line with the field, nothing measurable changed, which is what their theory predicted.
The paper confirms four predictions in all: the effect disappears without a sharp step in the glass, grows at steeper launch angles, appears for only one polarisation, and varies with wavelength the way the conventional Faraday effect does. A sideways field also produces a second, known effect that scales with the square of field strength. The team separated the two by isolating the signal that scales linearly.
"It wasn't hard to 3D print a rig to test our intuition," Sharif said in the university's statement. "Working out the theory for what we were seeing was the challenging part."
A sensor that responds to a sideways field could lie next to its target. Wits gives the example of fibre laid in a trench alongside an electrical cable. For a country with an ageing grid, a way to watch current along a route using glass that carries no electricity is an attractive idea.
The university is careful about how far that goes. Magnetic fields near most cables are much weaker than the 0.24 tesla used in the lab, and the sensitivity of a practical device has not been established.
Cox also raises a longer-term use. Replace the permanent magnets with a current-carrying coil and the light patterns inside a fibre could be steered electrically, which he says "could unlock a new way to do optical computing". His lab already works on laser links that carry data through open air. A separate Wits group, the Structured Light Laboratory, published an optical neural network in October.
"Often these things are right under our noses, hidden in the assumptions we have made for decades," Cox said.
The research was funded by the CSIR and the National Research Foundation. The paper is "Transverse Faraday effect in multimode fibers", Optics Letters volume 51, issue 19, with a preprint on arXiv dated 29 September.
The number that decides whether this becomes a product is the weakest field the effect can detect in a real installation. Nobody has measured that yet.
The paper confirms four predictions. The effect disappears when the glass has no sharp step. It grows at steeper launch angles. It appears for only one polarisation. It varies with wavelength the way the conventional Faraday effect does. A sideways field also produces a second, known effect that scales with the square of field strength. Sharif and Cox separated the two by isolating the signal that scales linearly with the field.
The figure in the university's account, and in the paper, is the one used here. At 0.24 tesla, about what sits near a strong neodymium magnet, the speckle pattern for light polarised across the field shifted until it was about 84% similar to the original. Light polarised in line with the field did not change in a way they could measure. That null result is what their theory predicted, because the weak guidance approximation drops the small component of the light that points along the fibre, and that component is strongest near the edge of the core in step-index fibre, where a sideways field can couple to it.
Fibre-based current sensors already use the Faraday effect Michael Faraday observed in 1845, but in those sensors the field runs along the fibre, so the fibre is usually coiled around the cable. The transverse version would let a fibre lie next to its target. Wits gives the example of fibre laid in a trench alongside an electrical cable. The university is explicit about the limit. Magnetic fields near most cables are much weaker than 0.24 tesla, and the sensitivity of a practical device has not been established. No sensor exists yet.
Cox's longer-term suggestion is separate from that sensing use. Replace the permanent magnets with a current-carrying coil and the light patterns inside a fibre could be steered electrically, which he says "could unlock a new way to do optical computing". His lab already works on laser links that carry data through open air. A separate Wits group, the Structured Light Laboratory, published an optical neural network in October. Neither of those is this experiment. This experiment is the magnet, the stationary multimode fibre, the 3D-printed rig and the speckle pattern at the far end.
The work was funded by the CSIR and the National Research Foundation. The paper is "Transverse Faraday effect in multimode fibers", Optics Letters volume 51, issue 19, with a preprint on arXiv dated 29 September. The university announced it on 11 November. The number that would decide whether any of this becomes a product is the weakest field the effect can detect in a real installation. Nobody has measured that yet.
Source: SA Tech News




